Conveyor belt method of use andmaintenance instructions

l.Direct sunlight or drenching should be avoided during conveyor belt in transit and in storagePrevent the contact with substances such as acid, alkaline and oils and organic solvent and so on,andrubber belt should be placed over one meter away from a heat source.2.The warehouse temperature should be ranging-18° -40° , and the reative humidity. During50%
80%storage.
3.The products should be place by rolls and should not be enfolded
4.They should be turned and moved once a quarter during storage.
5.Conveyor belts of different typespecs and layer should not be spliced and used.For splicingthebest way is via agglutination method.6.The operation speed of conveyor belt should generaiiy be lower than 4 meters per second.Formaterials of big lump and big abrasion and when the unloading is done by fixed unloading devices,try touse low speed.
7.The matching of drive drum diameter and the number of belt layersthe collocation of the drivedrum with turnabout drumand the requirement on the well angle of carrying roller should be stipulated
inaccordance with the conveyor design and selected reasonably.8.Feeding should be performed in the same direction as the belt running.To reduce the impact ofthe falling materials done to the belt chutes shall be set up to reduce the materials falling distance.Thesection that loads materials of rubber belt should use shortercarrying roller pitch and buffer roller toprevent spillage. The sides of the belt should adopt striker plate of proper flexibility lest rigid strikerplate scratch and damage the surface of the belt.
9.The following ayyention should be paid during operation
(1)It should prevent the carrying roller from being covered witn materials,shich would result inturning failure:Preventiong of the fallen materials being jammed between drums and belts.Attentionshould be paid to the lubrication on movingg parts, and it should not contaminate the belts(2)Loaded start-up should be avoided.
(3)A timely correction shall be carried out when off-track occurs.timely mending shall be donewhen there is a partial damage on the surface of the belt, to prevent the damaged parts form beingexpanded.
(4)To prevent the belt form being blocked by the frame,supporting pillar and lump materials.
After-sale service
Provide qualified products and satisfv service for our cliengts.Supply product catalogues and relative technology data for our cliengtsIntroduce rational product type, specification to our client.Offer installment.joint technooav service.Offer splicing materials and splicing instructions.Train splicing materials and splicing instructionsThe products practice” There Guarantee” and necessary assistance
concerning transportatiorWe quarantee to be responsibie for the quality of our product to the end.